STP 6B Cobalt Alloy Fiber Cutter
2022-02-18 15:34Introduction: Alloy 6B is a cobalt-based alloy used in abrasion environment, anti-seize, anti-wear and anti-friction. The friction coefficient of alloy 6B is very low, and it can produce sliding contact with other metals, and in most cases it will not produce wear. Even if no lubricant is used, or in applications where lubricant cannot be used, 6B alloy can minimize seizure and wear.
The wear resistance of alloy 6B is inherent and does not rely on cold work or heat treatment, so it can also reduce the workload of heat treatment and the cost of subsequent processing.
Alloy 6B is resistant to cavitation, impact, thermal shock and a variety of corrosive media. In the state of red heat, alloy 6B can maintain a high hardness (the original hardness can be restored after cooling). In both wear and corrosion In the environment, Alloy 6B is very practical.
application
Alloy 6B can be used to manufacture valve parts, pump plungers, steam engine anti-corrosion covers, high temperature bearings, valve stems, food processing equipment, needle valves, hot extrusion molds, forming abrasives, etc.
chemical composition
Co margin
Cr 28-32%
W 3.5-5.5%
Ni up to 3%
Fe up to 3%
C 0.9-1.4%
Mn up to 2%
Mo up to 1.5%
Mechanical behavior
Ultimate tensile strength 145ksi
Yield strength 90ksi
Elongation 12%
Hardness Rockwell C36